Kizashi AWD L4-2.4L (2010)
1. Remove fuel tank from vehicle.
2. Disconnect sub fuel level sensor connector (1).
3. Remove sub fuel level sensor (2) from fuel tank.
Installation
Reverse removal procedure, noting the following points.
-
Check that mating surface of sub fuel level sensor is clean.
-
Replace gasket with new one.
-
Tighten sub fuel level sensor screws to specified torque.
Tightening torque
Sub fuel level sensor screw: 1.6 N.m (0.16 kg-m, 1.5 lbf-ft) ((Reference))
-
After tightening screws, check for fuel leaks.
