Kizashi AWD L4-2.4L (2010)
Control Arm: Overhaul
Front Suspension
Suspension Arm Joint Dust Cover Disassembly and Reassembly
Disassembly
1) Remove suspension arm joint dust cover ring (1).
2) Remove suspension arm joint dust cover (2) using flat-end screwdriver.
Reassembly
Reverse disassembly procedure, noting the following point.
^
If suspension arm joint dust cover is replaced, apply a generous amount of grease (included in suspension arm joint dust cover set) to suspension
arm joint and inside of suspension arm joint dust cover.
Control Rod / Bushing Disassembly and Reassembly
Control Rod / Bushing Disassembly and Reassembly
Disassembly
1) Push out control rod bushing (2) by using special tool and hydraulic press (1).