Kizashi AWD L4-2.4L (2010)
Installation
Reverse removal procedure, noting the following points.
^
Upper arm bolt on the rear suspension frame end of upper arm must be inserted from front side of vehicle, while upper arm bolt on the suspension
knuckle end of upper arm must be inserted from rear side of vehicle.
^
The following bolts and nuts must use new.
-
Rear rear suspension frame front nut
-
Rear rear suspension frame rear bolt
-
Frame front bar front bolt
-
Frame front bar rear nut
CAUTION:
These bolt and nut are pre-coated with friction stabilizer. Never reuse bolt and nut. Otherwise, bolt and nut may loosen.
^
Tighten every part to specified torque.
Tightening torque
Upper arm nut (on rear suspension frame side): 75 Nm (7.6 kg-m, 55.5 lbf-ft)
Rear suspension frame front nut: 110 Nm (11.2 kg-m, 81.5 lbf-ft)
Rear suspension frame rear bolt: 110 Nm (11.2 kg-m, 81.5 lbf-ft)
Upper arm nut (on suspension knuckle side): 75 Nm (7.6 kg-m, 55.5 lbf-ft)
Rear suspension frame front bar bolt: 65 Nm (6.6 kg-m, 48.0 lbf-ft)
Rear suspension frame front bar nut: 110 Nm (11.2 kg-m, 81.5 lbf-ft)
Wheel speed sensor bracket bolt: 25 Nm (2.5 kg-m, 18.5 lbf-ft)