Kizashi AWD L4-2.4L (2010)
Clutch Disc: Service and Repair
Clutch Cover and Clutch Disc Removal and Installation
Clutch Cover and Clutch Disc Removal and Installation
Reference: Clutch Cover and Clutch Disc Components
Removal
1) Dismount manual transaxle assembly.
2) Hold flywheel with special tool and remove clutch cover bolts (1), clutch cover (2) and clutch disc.
Special Tool
(A): 09924-17811
Installation
Reference: Clutch Cover and Clutch Disc Inspection
NOTE:
Before installation, make sure that flywheel surface and pressure plate surface are cleaned and dried thoroughly.
1) Hold flywheel with special tool (A).
2) Align clutch disc with crankshaft center using special tool (B) and install clutch cover (1).
3) Install and tighten clutch cover bolts using the following procedures:
a) Tighten 3 bolts (3) by hand.
b) Tighten other 3 bolts (4) evenly and gradually to 5.0 Nm (0.51 kgf-m, 4.0 lbf-ft).
c) Fully tighten all bolts (3), (4) evenly and gradually to specified torque in numerical order ("1" - "6") starting from bolt nearby strut plate rivet
(2).
NOTE:
While tightening clutch cover bolts, make sure that clutch disk spline is centered.