Kizashi AWD L4-2.4L (2010)
Rain Sensor: Procedures
Rain / Light Sensor Setting Change Procedure (If Equipped)
1. Check that vehicle is in the following conditions.
-
Ignition mode of keyless push start system is "OFF".
-
Wiper and washer switch is OFF.
-
Lighting switch is OFF.
-
Wiper is in park positions.
-
Temperature around rain / light sensor is 5 to 40 °C (41 to 120 °F).
-
Vehicle is stopped.
-
Adjustment knob (1) is as shown in figure.
2. Perform the following procedure within 10 seconds.
a. Push engine switch to change ignition mode of keyless push start system to "ON".
b. Wait for 3 seconds.
c. Change position of adjustment knob in sequence of 5-->4-->5 within 1 second.
d. Change position of adjustment knob in sequence of 5-->1-->5 within 1 second.
e. Change position of adjustment knob in sequence of 5-->4-->5 within 1 second.