Reno L4-2.0L (2006)
8. Remove the rubber boot.
9. Holding the hex nut, twist off the pushrod clevis.
10. Remove the hex nut from the pushrod.
Installation
1. Check the pushrod and the pushrod clevis for damage and proper fit.
2. Install the hex nut and the pushrod clevis on the booster shaft.
Tighten: Tighten the booster hex nut and the pushrod clevis to 18 Nm (13 ft. lbs.).
3. Measure the distance from the booster to the center of the fork pin bore.
