Reno L4-2.0L (2006)
Valve Body: Service and Repair
Control Valve Body Assembly Removal and Installation
Tools Required: DW260-070 Plug Remover/Installer
Removal
1. Disconnect the negative battery cable.
2. Disconnect the transaxle wiring harness and the park/neutral position switch electrical connector.
3. Raise and suitably support the vehicle.
4. Remove the engine under cover.
5. Remove the transaxle fluid drain plug using the plug remover/installer DW260-070 and drain the transaxle fluid.
6. Remove the oil pan, oil pan gasket.
7. Remove the valve body mounting bolts.
8. Remove the automatic transmission input speed sensor mounting bolt.
9. Tilt the valve body.