Sidekick 2WD L4-1590cc 1.6L SOHC 0 TBI 8V (1992)
ABS Main Relay: Testing and Inspection
Fig. 19 RWAL Relay Resistance Inspection
Fig. 20 RWAL Relay Continuity Inspection
1.
Disconnect battery ground cable, then remove monitor coupler bracket.
2.
Disconnect yellow coupler from RWAL relay, then remove RWAL relay from its bracket.
3.
Check resistance between terminals A and B, then terminals C and D, Fig. 19.
4.
Resistance between terminals A and B should be infinity.
5.
Resistance between terminals C and D should be 90-110 ohms.
6.
If resistance is as specified, proceed to step 7. If resistance is not as specified, replace relay.
7.
Check that there is continuity between terminals A and B when battery is connected to terminals C and D, Fig. 20.
8.
Replace relay if not as specified.