Sidekick 4 Door 4WD L4-1.8L DOHC MFI 16V (1996)
PASSIVE ARMING AND SHOCK SENSOR TEST
NOTE:
Passive arming is for 1994-1995 vehicles only. If you desire passive arming for a 1996 alarm system, connect the blue loop wires together, located
on the side of the alarm controller.
1.
Open the driver's side door.
2.
Close the door.
3.
Wait for 30 seconds. Alarm will arm and the following should occur:
^
siren chirps once;
^
parking lights flash once;
^
LED starts flashing slowly.
If the above do not happen:
(1) check for a break in the light blue loop wire located on the side of the alarm controller;
(2) check the pin switch wire and connectors;
(3) check the door pin switches.
After an additional 10 seconds,
^
doors lock (if equipped with power door locks).
4.
Check the shock sensor by kicking a tire. The following should occur:
^
siren will go off;
-
if not, refer to Diagnostic Guide symptom # 3.
^
parking lights will flash continuously;
-
if the sensor is too sensitive or insensitive, refer to Diagnostic Guide symptom # 4 and # 5.
5.
Press the button on the remote transmitter to disarm the system. The following should occur:
^
siren will shut off;
^
parking lights will flash four times;
^
siren will chirp four times;
LED starts to flash rapidly, indicating that alarm will re-arm itself in 30 seconds.
DOOR TRIGGER TEST
1.
Press the button on the remote transmitter to arm the system.
2.
Wait for 5 seconds.
3.
Open the rear door slowly to avoid engagement of the shock sensor. The following should occur:
^
siren will go off;
^
parking lights will flash continuously.
If the above do not happen:
(1) check for a break in the light blue loop wire located on the side of the alarm controller;
(2) check the pin switch wire and connectors;
