Sidekick 4 Door 4WD L4-1.8L DOHC MFI 16V (1996)
2.
Remove the glove box from the passenger side.
3.
Remove the 12-pin wire harness from the main unit. Be careful not to cut any wires.
4.
Remove all bullet and plug connectors from the harness and remove the harness.
^
Gray wire: Unplug the gray wire from the domelight connector located in the door frame post between the front and rear doors on the
passenger side of the vehicle.
5.
Install new harness into vehicle. Plug harness into the main unit and connect all bullet and plug connectors.
6.
Re-install the speaker cover.
7.
Re-install the glove box.
D. Door Lock Wiring Harness
D.
Door Lock Wiring Harness
(1994-1995 vehicles: pin 99980-46060-004; 1996 vehicles: p/n 99980-46061-004)
1.
Remove the driver's side speaker cover and speaker from the kick panel.
2.
Reach inside and disconnect the blue plug connector.
3.
Remove RH speaker cover and Glove Box Pivot Pin.
4.
Remove the glove box from the passenger side.
5.
Unplug the blue 2-pin wire connector from the main control unit. Remove the door lock wiring harness by pulling it through to the driver's
side of the vehicle.
6.
Plug in the blue 2-pin connector from the new harness to the main control unit. Run the wire under the dash to the door lock (blue plug
connector). Make sure the connection is secure.
7.
Reinstall the speaker covers and glove box.
E. Switch Panel With L.E.D. and Valet Override Switch
E.
Switch Panel with L.E.D. and Valet Override Switch
(1994-1995 vehicles: p/n 99980-46060-005; 1996 vehicles: p/n 99980-46061-005)
1.
Locate and remove the dash panel under the steering column.
2.
Locate the small white 4-pin plug connector on the main alarm wiring harness and disconnect it.
3.
Remove the switch panel from the dash.
4.
Insert the new switch panel into the dash and connect the 4-pin connector.
5.
Reinstall the dash panel under the steering column.
F. Siren
F.
Siren (1994-1995 vehicles: p/n 99980-46060-006; 1996 vehicles: p/n 99980-46061-006)
1.
Remove the RH speaker cover and Glove Box Pivot Pin.
2.
Remove the glove box from the passenger's side dash.
3.
Locate the red siren lead wire on the main wiring harness and disconnect it from its bullet plug.
4.
Locate the siren under the hood on the firewall. Pull the red siren wire through the grommet in the firewall into the engine compartment.
5.
Disconnect the mounting bolt that holds the siren into place. Remove the siren.
6.
Install the new siren back into position with the supplied bolt. When bolting the siren back into place, be sure to connect the ring connector
ground wires from the siren.
7.
Push the red wire with the male bullet connector through the grommet in the firewall. From inside the vehicle, pull the excess wire into the
