Sidekick 4WD L4-1590cc 1.6L SOHC 0 TBI 8V (1990)
Bowl Vent Solenoid: Testing and Inspection
1.
Disconnect canister hose from bowl vent (C) nozzle of the storage canister and connect new hose to pipe leading to solenoid.
2.
Blow air into test hose with ignition switch in both On and Off positions. Air should pass through hose in both tests.
3.
Start engine and allow to idle, then blow air through test hose. Air should not pass through solenoid.
4.
If SVS fails to perform as outlined, check feed circuits from ECM and ignition switch and repair as needed. If feed circuits are satisfactory, SVS is
defective.
5.
Remove test hose and reconnect original hose to canister.
