Sidekick 4WD L4-1590cc 1.6L SOHC 0 TBI 8V (1990)
-
Shift arm should be installed at the same time.
3. Drive in spring pin (single short) for reverse gear shift limit yoke.
4. Drive in spring pin (double) for shift lever.
5. Drive in spring pin (single long) for return spring.
6. Fit straight end of shift limit spring into line groove in shift limit yoke and with its other hooked end turned in its winding direction by about 90—
from its free state, hook it on spring pin.
7. Drive in spring pin for shift arm.
8. Press-fit case plug into case and caulk it with punch.
9. After applying grease "A", install select guide pins, select return springs end spring bolts and torque them to (a) 23 Nm (17.0 ft. lbs.)
NOTE: Double coil spring is required at 5th/Reverse select side.
10. Clean mating surfaces of both case plate and case, apply sealant "B" to case side evenly, mate them and fasten with screws.
