Sidekick JS 2D 2WD L4-1.6L (1998)
^
Air bag being deployed
^
Trim cover (pad surface) being cracked
^
Wire harness or connector being damaged
^
Air bag (inflator) module being damaged or having been exposed to strong impact (dropped)
INSTALLATION
1. Install air bag (inflator) module to steering wheel, taking care so that no part of wire harness is caught between them.
2. Tighten air bag (inflator) module left side bolt first and then its right side bolt to specified torque.
Special Tool (A): 09944-18230
Tightening Torque (a): 23 Nm (2.3 kg-m, 17.0 ft. lbs.)
Make sure that clearance between module and steering wheel is uniform all the way.
3. Connect horn connectors securely, fit connector onto projection of steering wheel right side cap and then install right side cap on steering wheel
lower cover.
4. Connect negative battery cable.
5. Enable air bag system. Refer to Air Bags and Seat Belts.
