Sidekick JS 2D 2WD L4-1.6L (1998)
Clutch Release Bearing: Service and Repair
CLUTCH RELEASE SYSTEM
REMOVAL
1. Drive out No.1 bush (release arm side) by using special tool and hammer.
Special Tool
(A): 09922-46010
2. Remove release shaft and spring.
3. Remove No.2 bush by using a flat end rod or the like.
INSPECTION
1. Check clutch release bearing for its smooth rotation.
2. Inspect smoothness of input shaft bearing retainer and correct or replace it as necessary.
CAUTION: Do not wash release bearing. Washing may cause grease leakage and consequential bearing damage.
INSTALLATION
NOTE: DO NOT apply grease to No.1 and No.2 bush.
1. Install new No.2 bush.
2. Install release shaft with return spring.
3. Drive in a new No.1 bush until its end contacts stepped surface of clutch housing using special tools and hammer.
Special Tool
(B): 09925-98221
(C): 09927-34510