Sidekick JS 2D Soft Top 2WD L4-1.6L (1997)
1. Insert new stud in hub hole. Rotate stud slowly to assure serrations are aligned with those made by original bolt.
2. Using special tools, press-fit bearing outer race until its end contacts stepped surface of wheel hub.
Special Tool:
(D): 09944-68210
(E): 09924-74510 or equivalents.
NOTE:
^
As front wheel bearing is cassette type double taper roller bearing, it must be replaced as whole unit when replacement becomes necessary.
^
Cassette type double taper roller bearing is so designed as to provide proper pre-load as long as it is tightened to specified torque. Therefore, it
requires no pre-load check after installation, unlike conventional taper roller bearing.
^
Apply wheel bearing grease between bearings.
"A": Grease 99000-25010 or equivalent.
3. Install bearing circlip.