Sidekick JS 2D Soft Top 2WD L4-1.6L (1997)
NOTE:
-
Cut off in shift shaft should face downward when shift shaft is installed.
-
Use care for installing direction of shift limit spring (a).
-
Shift arm should be installed at the same time.
3. Drive in spring pin (single short) for reverse gear shift limit yoke.
4. Drive in spring pin (double) for shift lever.
5. Drive in spring pin (single long) (1) for return spring.
6. Fit straight end of shift limit spring (2) into line groove in shift limit yoke (3) and with its other hooked end turned in its winding direction by
about 90° from its free state, hook it on spring pin (1).
7. Drive in spring pin for shift arm.
8. Press-fit case plug (1) into case (2) and caulk it with punch.
9. If reverse gear shift limit bolt (1) has been removed, apply thread lock cement then install and torque it to specification.
"A": Cement 99000-32020
Tightening Torque
(a): 32 Nm (3.2 kg-m, 23.0 ft. lbs.)
10. Install gear shift lever case (2) to transmission without using sealant for functional check.
