Sidekick JSS 4D Hard Top 2WD L4-1.8L (1997)
Timing Cover: Service and Repair
Installation
INSTALLATION
Reverse removal sequence to install timing chain cover noting following points.
1. Apply sealant "A" to area as shown in figure.
"A": Sealant 99000-31150 or equivalent.
2. Apply engine oil to oil seal lip, then install timing chain cover. Tighten bolts and nut to specified torque.
Tightening Torque (a): 11.0 Nm (1.1 kg-m, 8.0 ft. lbs.).
NOTE: Before installing timing chain cover, check that pin is securely fitted.
3. Install crankshaft pulley. To lock crankshaft pulley, use special tool (camshaft pulley holder) with it at shown in figure.