Sidekick JSS 4D Hard Top 2WD L4-1.8L (1997)
Transmission Range Switch: Testing and Inspection
Select Cable/Transmission Range Switch
SELECT CABLE/TRANSMISSION RANGE SWITCH
SELECT CABLE
ADJUSTMENT
1) Before tightening cable end nut, shift select lever to "N".
2) Also shift manual shift lever to "N".
NOTE:
-
Make sure that nut and cable joint have clearance under above conditions.
-
If select cable has been moved, push it in arrow C direction as shown in figure at the left till it stops and then confirm that select lever is in "N"
position.
3) Turn nut A by hand till it contacts manual select cable joint.
Then tighten nut B with wrench.
4) After select cable was installed, check for the following.
-
Push vehicle with select lever shifted to "P". Vehicle should not move.
-
Vehicle can not be driven in "N".
-
Vehicle can be driven in "D", "2", and "L".