Sidekick JSS 4D Hard Top 2WD L4-1.8L (1997)
4. Press-fit wheel bearing, retainer ring and new sensor rotor as shown.
NOTE:
^
Use care not to cause any damage to outside of retainer ring.
^
Refer to figure so that wheel bearing and are retainer ring installed in proper direction.
5. Apply grease to axle shaft inner oil seal lip as shown.
"A": grease 99000-25010 or equivalent.
6. Apply sealant to mating surface of bearing retainer with brake back plate.
NOTE: Make sure to remove old sealant before applying it anew.
"B": Sealant 99000-31110 or equivalent.
7. Install rear axle shaft to rear axle housing and tighten bearing retainer nuts to specified torque.
NOTE: When installing rear axle shaft, be careful not to cause damage to oil seal lip in axle housing.
Tightening Torque (a): 23 Nm (17.0 ft. lbs.)