Sidekick JX 2D 4WD L4-1.6L (1998)
9. Remove generator adjust arm stiffener.
10. Remove intake manifold stiffener, No. 1 stiffener and No. 2 stiffener with EGR pressure transducer.
11. Disconnect bypass hose of engine coolant from intake manifold.
12. Remove intake manifold with surge tank and throttle body from cylinder head, and then its gasket.
INSTALLATION
Reverse removal procedure for installation noting the followings.
-
Use new intake manifold gasket.
-
When installing intake manifold, install clamps at positions as shown in figure.
Tightening Torque (a): 23 Nm (17.0 ft. lbs.)