Sidekick JX 4D Hard Top 4WD L4-1.6L (1997)
1.
Clean off any dirt or grease from the exterior of the pump.
2.
Carefully mount the pump into a vise with soft jaws to protect the pump housing.
3.
Remove the suction connector bolt, suction connector and 0-ring from the pump body.
4.
Remove the power steering pressure switch (terminal set) from the pump body.
6.
Remove the plug, flow control spring and relief valve (flow control valve) from the pump body.
6.
Remove the cover bolts, pump cover and O-ring from the pump body.
7.
Remove the snap ring from the pump shaft.
8.
Remove the vanes from the rotor.
9.
Remove the cam ring, rotor, side plate and O-rings from the pump body.
10.
ReMove the pulley from the pump body.
11.
Remove the oil seal from the pump body.
Inspection
Pump Body, Cover, Side Plate and Shaft Check the sliding surfaces of each part for deterioration and/or damage. If any defect is found, replace the pump
assembly.