Sidekick JX 4D Hard Top 4WD L4-1.6L (1997)
Mainshaft: Service and Repair
Assembly
NOTE:
-
Before installation, wash each part and apply specified gear oil to sliding faces of bearing and gear.
-
Use new circlips on shaft for reinstallation. Don't reuse used circlips.
1. Fit sleeve to low speed hub, place 3 synchronizer keys in it and set synchronizer spring. Refer to figure for proper installing direction of hub,
sleeve and springs. Synchronizer key has no specific direction for installation.
NOTE: When installing each synchronizer spring, insert its hooked end to hub hole and put it toward right.
2. Install needle bearing, 2nd gear and 2nd synchronizer ring to main shaft.