Sidekick Sport 2D JLX 4WD L4-1.8L (1998)
INSPECTION
Check oil seal lip for fault or other damage. Replace as necessary.
NOTE: When installing new oil seal, top it in until its surface is flash with edge of timing chain cover.
To install oil seal, use special tool (bearing installer).
Special Tool (A): 09913-75510
INSTALLATION
Reverse removal sequence to install timing chain cover noting following points.
1. Apply sealant "A" to area as shown in figure.
"A": Sealant 99000-31150
2. Apply engine oil to oil seal lip, then install timing chain cover. Tighten bolts and nut to specified torque.
NOTE: Before installing timing chain cover, check that pin is securely fitted.
Tightening Torque (a): 11.0 Nm (8.0 ft. lbs.)