Sidekick Sport 2D JLX 4WD L4-1.8L (1998)
Camshaft Position Sensor: Service and Repair
CAMSHAFT POSITION (CMP) SENSOR
CAUTION: Disassembly is prohibited. If anything faulty is found, replace as an assembly unit.
REMOVAL
1) Disconnect CMP sensor coupler.
2) Remove CMP sensor by removing bolts.
INSTALLATION
NOTE: After installing CMP sensor, adjust ignition timing.
1) Apply engine oil to 0-ring and install it onto groove of CMP sensor.
2) Install CMP sensor to camshaft.
Fit the dog of CMP sensor coupling into the slots of camshaft, when installing. The dogs of CMP sensor coupling are offset. Therefore, if the dogs
can not be fitted into the slots, turn the CMP sensor shaft by 180 degree and try again.
3) Tighten CMP sensor bolts.
Tightening Torque
(a): 15 N.m (1.5 kg-m, 11.0 lb-ft)
4) Connect CMP sensor coupler.