Sidekick Sport 2D JLX 4WD L4-1.8L (1998)
Whenever shift solenoid valves and TCC (lock-up) solenoid valve are removed from transmission, verify their valve function physically before they
are reinstalled.
1. Apply oiler to solenoid valve and give compression by hands and then check to be sure that transmission fluid from oiler does not come out of
holes in solenoid valve when battery voltage is not conducted.
2. Under the same conditions as above, conduct battery voltage and then make sure that fluid comes out with vigor.
NOTE:
^
If fluid does not come out with vigor in above step 2 inspection, do not re-use that solenoid valve.
^
Image shows shift solenoid valve check. Check TCC solenoid valve also in the same way.
INSTALLATION
Reverse removal procedure to install solenoid valves and note the following points.
-
Install the solenoid valve and use a new gasket and O-ring.
-
Install the oil tubes in the order as shown.
-
Install the oil pan and use a new gasket.
-
Tighten oil cooler pipe flare nut, universal joint flange bolts & nuts and exhaust pipe bracket bolts to specified torque.
-
Fill with A/T fluid and check the level.
-
Check for fluid leakage after warming up A/T.
