Sidekick Sport 2D JLX 4WD L4-1.8L (1998)
Shift Interlock Cable: Service and Repair
INTERLOCK CABLE
NOTE: Don't bend interlock cable excessively when removing and installing it, or system will not operate correctly.
REMOVAL
1. Disable air bag system.
2. Down steering column by removing 4 bolts.
3. Remove meter hood and then steering cover.
4. Remove interlock cable clamp screw located at ignition switch assembly.
5. Disconnect interlock cable inner end form key interlock lever.
6. With console box removed, take out interlock cable by loosening lock nuts.
7. Detach cable end from release cam while pressing claws of release cam boss. At this time, be careful not to cause damage to its claws.
INSTALLATION
1. Shift select lever to "N" range and turn ignition key to "ACC" position.
2. Connect inner end of interlock cable to key interlock lever. (Ignition switch side.)
3. Install outer end bracket of interlock cable to ignition switch assembly, and tighten screw to specified torque.
Tightening Torque
"a": 2.2 Nm (0.22 kg-m, 1.5 ft. lbs.)