Sidekick Sport 2D JLX 4WD L4-1.8L (1998)
Clutch Master Cylinder: Service and Repair
Disassembly and Assembly
DISASSEMBLY AND ASSEMBLY CLUTCH MASTER CYLINDER
DISASSEMBLY
1. Remove boot and then circlip with piston pushed in.
2. Blow compressed air gradually into hole for pipe connection to remove piston assembly, using care to prevent it from jumping out.
INSPECTION
Inspect all disassembled parts for wear or damage and replace parts if necessary.
NOTE:
^
Wash disassembled parts with brake fluid.
^
Do not reuse piston assembly and circlip.
Inspect cylinder bore for scoring or corrosion. It is best to replace corroded cylinder. Corrosion can be identified as pits or excessive roughness.
NOTE: Polishing bore of cylinder with anything abrasive is prohibited, as damage to cylinder bore may occur.
Rinse cylinder in clean brake fluid. Shake excess rinsing fluid from cylinder. Do not use a cloth to dry cylinder, as lint from cloth cannot be kept
away from cylinder bore surfaces.
ASSEMBLY
