Sidekick Sport 2D JLX 4WD L4-1.8L (1998)
Clutch Slave Cylinder: Service and Repair
CLUTCH OPERATING CYLINDER
REMOVAL
NOTE: Do not allow fluid to get on painted surfaces.
1. Clean around reservoir cap and take out fluid with syringe or such.
2. Disconnect fluid hose from operating cylinder.
3. Remove operating cylinder attaching bolts and operating cylinder.
INSTALLATION
1. For air bleeding of master cylinder alone, it must be removed from vehicle.
2. Apply small amount of grease to rod tip.
"A": Grease 99000-25010
NOTE: Don't allow any grease to be on boot.
3. Install clutch operating cylinder and torque attaching bolts to specification.
4. Connect clutch fluid hose and torque union bolt to specification.
Tightening Torque
(d): 50 Nm (5.0 kg-m, 36.0 ft. lbs.)
(e): 23 Nm (2.3 kg-m, 16.5 ft. lbs.)