Sidekick Sport 2D JLX 4WD L4-1.8L (1998)
Axle Shaft: Service and Repair
REMOVAL
1. Disconnect negative (-) cable at battery.
2. Hoist vehicle.
3. Remove rear wheel speed sensor from rear axle.
CAUTION:
^
Do not pull wire harness when removing rear wheel speed sensor.
^
Do not cause damage to surface of rear wheel speed sensor or pole piece and do not allow dust, etc. to enter its installation hole.
4. Remove rear brake drum. Refer to Brakes and Traction Control.
5. Drain gear oil from rear axle housing by loosening drain plug.
6. Remove rear wheel bearing retainer nuts from axle housing.