Swift L4-1298cc 1.3L SOHC 3 TBI 8V (1990)
Engine Control Module: All Technical Service Bulletins
No/Hard Starting - When Engine Cold
Division:
Automotive
Category:
Technical
TSB No. TS 4-12 10300
Section Title:
Engine
SUBJECT:
NO OR HARD START/ENGINE FLOODED WHEN COLD
MODEL:
SOHC
YEAR:
1989 AND 1990
CONDITION No or hard start/engine flooded when the ambient temperature is approximately 32~F. This condition is experienced especially in the high
altitude areas.
REPAIR
Install the countermeasure Cold Start Harness Set (P/N 36690-60A00). On the back of this page are the installation instructions for this vehicle. To
prevent any damage to the ECM be sure to follow these instructions!
1.
Be sure the ignition switch is in the "off" position.
2.
Remove the two (2) mounting screws from junction/fuse block. Pull it down to gain access to the ECM connectors.
3.
Disconnect the ECM connectors and pull the harness down for service.
4.
Remove the tape from the harness to expose the ECM's connector wires, as shown in the illustration.