Swift L4-1298cc 1.3L SOHC MFI (1997)
Temperature Gauge: Testing and Inspection
COOLANT (WATER) TEMPERATURE METER AND SENDER GAUGE
INSPECTION
COOLANT (WATER) TEMPERATURE METER
1) Disconnect Y/W (Yellow/White) lead wire going to sender gauge installed to intake manifold.
2) Use a bulb (12V 3.4W) in position to ground wire as illustrated.
3) Turn main switch ON.Confirm that bulb is lighted with meter pointer fluctuating several seconds thereafter. If meter is faulty, replace.
SENDER GAUGE (IN ECT SENSOR)
Warm up sender gauge.Thus make sure its resistance is decreased with increase of its temperature.