Swift L4-1298cc 1.3L SOHC MFI (1997)
3. Apply grease to outside bearing, outside inner race and oil seal lip.
"A": Grease 99000-25010 or equivalent.
4. Install wheel hub to knuckle by tightening drive shaft nut. Don't tap wheel hub.
5. Install brake disc.
Tightening Torque (a): 4 - 7 Nm (3.0 - 5.0 ft. lbs.)
6. Install brake caliper/caliper carrier.
7. Tighten caliper carrier bolts to specified torque.
Tightening Torque (b): 40 - 60 Nm (29.0 - 43.0 ft. lbs.)
8. Depress foot brake pedal and hold it there.
Tighten new drive shaft nut and brake disc screws to specified torque.
Tightening Torque (c): 150 - 200 Nm (108.5 - 144.5 ft. lbs.)
9. Calk drive shaft nut as shown.
WARNING: Be careful while calking nut so that no crack will occur in calked part of nut. Cracked nut must be replaced with new one.
10. install wheel and lower hoist.