Swift L4-1298cc 1.3L SOHC MFI (1997)
Camshaft Position Sensor: Adjustments
Signal Rotor Air Gap
1. Remove distributor cap and rotor.
2. Using thickness gauge, measure air gap, between signal rotor tooth and CMP sensor (generator).
Signal rotor air gap "a": About 0.2 mm (about 0.008 in.)
3. If gap is out of specification, loose CMP sensor (signal generator) securing screws. Using blade (-) screw driver, move CMP sensor (generator)
and adjust gap to specification. After adjustment, tighten securing screws and recheck gap.
NOTE: Check to make sure that CMP sensor (signal generator)
tooth is free from any metal particles.
4. Install distributor cap and rotor.