Swift L4-1298cc 1.3L SOHC MFI (1997)
INSTALLATION
Before installation,inspect plunger joint for wear and replace defective parts.
1) Apply grease.
2) Install switch assembly into front housing,referring to left figure especially for its vertical direction.And then tighten screws.
3) Connect wire from motor to magnetic switch terminal.
4) Check switch for operation.
MOTOR BRUSH
REMOVAL
1) Remove rear bracket.
2) Remove brush holder and brushes.
INSTALLATION
Install in reverse order of REMOVAL,noting the following.
1) Apply grease.
2) Install brush holder to armature while pushing 4 brushes outward.
3) Install rear bracket.
4) Check motor for operation.