Swift L4-1298cc 1.3L SOHC MFI (1997)
Rear Knuckle: Service and Repair
Front
REMOVAL
1. Hoist vehicle and remove wheel.
2. Remove wheel hub. Refer to Transmission and Drivetrain.
3. Disconnect tie-rod end from knuckle with special tool (A).
Special Tool (A): 09913-65210 or equivalent.
4. Remove strut bracket bolts from strut bracket and then ball stud bolt.
5. Disconnect coupler of ABS wheel speed sensor. (If equipped).
6. Remove knuckle.
INSTALLATION
1. Install knuckle to ball stud on suspension arm and strut bracket. Installing direction of each bolt is as shown. Align knuckle bolt hole with ball stud
groove as shown and install ball stud bolt. Tighten each nuts to specified torque.
Tightening Torque: (d): 50 - 70 Nm (36.5 - 50.5 ft. lbs.)
2. Connect coupler of ABS wheel speed sensor. (If equipped).