Swift L4-1298cc 1.3L SOHC MFI (1997)
Release Bearing: Service and Repair
REMOVAL
1. Remove release arm by loosening its bolt.
2. Take out release bearing by turning release shaft.
3. Unhook return spring by using pliers.
4. Drive out No.2 bush by using Special Tool (A): 09922-46010, or equivalent and hammer. Release shaft seal will also be pushed out.
5. Remove release shaft.
6. For removal of No.1 bush, tap it by using M16 x 1.5 tap.
7. Leaving tap in No. 1 bush, screw in joint pipe over tap, join sliding shaft with joint pipe, and then drive out bush using Special Tool (B):
09923-46020 and (C): 09930-30102, or equivalent.
INSPECTION
1. Check clutch release bearing for smooth rotation.
2. Inspect smoothness of release bearing retaining portion of transmission case and correct or replace right case as necessary.
CAUTION: Do not wash release bearing. Washing may cause grease leakage and consequential bearing damage.
INSTALLATION