Swift L4-1298cc 1.3L SOHC MFI (1997)
Shift Rail: Service and Repair
GEAR SHIFT AND SELECT SHAFT ASSEMBLY
1. To disassemble component parts, use special tools and 2.8 - 3.0 mm (0.11 inch) pin remover in addition.
Special Tools:
(A): 09922-85811 (4.5 mm)
(B): 09925-78210 (6.0 mm)
2. Clean all parts thoroughly, inspect them and replace with new ones as required.
3. Assemble component parts by reversing removal procedure.
NOTE:
^
When driving in spring pins, prevent shaft from being bent by supporting it with wood block.
^
Assemble 5th and Reverse (REV) gear shift cam by winding cam guide return spring, and then drive in spring pin.
^
Locate low speed select spring (Blue-Lower position) and reverse select spring (Red-Upper position) correctly.