Swift GA L4-1298cc 1.3L SOHC MFI (2001)
Brake Master Cylinder: Service and Repair
Brake Fluid Reservoir
REMOVAL
1. Disconnect reservoir lead wire at coupler.
2. Clean outside of reservoir.
3. Take out fluid with syringe or such.
4. Remove reservoir connector pin by using special tool.
Special Tool
(A): 09922-85811
5. Remove reservoir.
NOTE: Do not allow brake fluid to get on painted surfaces.
INSTALLATION
WARNING: All brake fasteners are important attaching parts in that they could affect the performance of vital parts and systems, and/or
could result in major repair expense. They must be replaced with ones of same part number or with an equivalent part if replacement
becomes necessary. Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during
reassembly to assure proper retention of all parts. There is to be no welding as it may result in extensive damage and weakening of the metal.
1. When using new grommets, lubricate them with the same fluid as the one to fill reservoir with. Then press-fit grommets to master cylinder.
Grommets must be seated in place.