Swift GA L4-1298cc 1.3L SOHC MFI (2001)
Vacuum Brake Booster: Testing and Inspection
INSPECT BOOSTER PARTS
RUBBER PARTS
Wipe fluid from rubber parts and carefully inspect each rubber part for cuts, nicks or other damage.
If there is any question as to serviceability of rubber parts, REPLACE them.
METAL PARTS
BADLY DAMAGED ITEMS, OR THOSE, WHICH WOULD TAKE EXTENSIVE WORK OR TIME TO REPAIR, SHOULD BE REPLACED. IN
CASE OF DOUBT, INSTALL NEW PARTS.
INSPECT/ADJUST CLEARANCE BETWEEN BOOSTER PISTON ROD AND MASTER CYLINDER PISTON
The length of booster piston rod is adjusted to provide specified clearance "a" between piston rod end and master cylinder piston.
^
Before measuring clearance, push piston rod several times so as to make sure reaction disc is in place.
^
Keep inside of booster at atmospheric pressure for measurement.
1. Set special tool (A) on master cylinder and push pin until contacts piston.
Special Tool
(A): 09950-96010
2. Turn special tool upside down and place it on booster. Adjust booster piston rod length until rod end contacts pin head.
Clearance "a" (Between special tool and piston rod): 0 mm (0 inch)