Swift GA L4-1298cc 1.3L SOHC MFI (2001)
Hold camshaft between two "V" blocks, and measure runout by using a dial gauge.
If runout exceeds the limit, replace camshaft.
Runout limit: 0.10 mm (0.0039 inch)
Camshaft Journal Wear
Check camshaft journals and camshaft housings for pitting, scratches, wear or damage.
If any malcondition is found, replace camshaft or cylinder head with housing. Never replace cylinder head without replacing housing.
Check clearance by using gaging plastic.
The procedure is as follows.
1. Clean housing and camshaft journals.
2. Install camshaft to cylinder head.
3. Place a piece of gaging plastic the full width of journal of camshaft (parallel to camshaft).
4. Install camshaft housing.
5. Tighten camshaft housing bolts in such order as indicated in figure a little at a time till they are tightened to specified torque.
Tightening Torque
(a): 11 Nm (1.1 kg-m, 8.0 ft. lbs.)
NOTE: Do not rotate camshaft while gaging plastic is installed.
