Swift GA L4-1298cc 1.3L SOHC MFI (2001)
3. Clean glass surface to be adhered to window with clean cloth.
If unleaded gasoline is used, let it dry for more than 10 minutes.
4. Attach glass into new molding (3).
5. Clean molding surface with clean cloth.
6. Using a new brush (1), apply sufficient amount of primer (2) for glass along glass surface be adhered to window.
NOTE:
-
Be sure to refer to maker's instruction for proper handling and drying time.
-
Do not touch primer coated surface.
Area applied primer coated surface
Width "a" : Approx. 20 mm (0.78 in.)
7. Using new brush, apply sufficient amount of primer for molding (1) (urethane) and dam to surface "A" as shown in the figure.
8. Apply adhesive (3) as shown.
NOTE:
-
Start from bottom side "E" of glass (4).
-
As for rear side "F" of glass, apply adhesive so that shape of the adhesive applied part matches shape of primer coated part of body (as in Step
2)).
Adhesive amount specification
Height "b" : Approx. 16 mm (0.63 in.)
Width "c" : Approx. 9 mm (0.35 in.)
Width "d" : Approx. 2.5 mm (0.10 in.)
