Swift GL L4-1298cc 1.3L SOHC MFI (2000)
5. Repeat this operation 3) and 4) until there are no more air bubbles in hydraulic line.
6. When bubbles stop, depress and hold brake pedal and tighten bleeder plug (A).
Tightening Torque
(a): 11 Nm (1.1 kg.m, 8.0 ft. lbs.)
7. Repeat steps 1) through 6) for bleeder plug (B).
8. Bleed from brake calipers/wheel cylinders as shown procedure below.
NOTE: Perform bleeding operation starting with wheel cylinder farthest from master cylinder and then at front caliper of the same brake line. Do
the same on the other brake line.
1. Fill master cylinder reservoir with brake fluid and keep at least one-half full of fluid during bleeding operation.
2. Remove bleeder plug cap. Attach a vinyl tube to bleeder plug, and insert the other end into container.
3. Depress brake pedal several times, and then while holding it depressed, loosen bleeder plug about one-third to one-half turn.
