Swift GL L4-1298cc 1.3L SOHC MFI (2000)
Front Steering Knuckle: Service and Repair
REMOVAL
1. Hoist vehicle and remove wheel.
2. Remove wheel hub.
3. Disconnect tie-rod end from knuckle with special tool (A).
Special Tool
(A): 09913-65210
4. Remove strut bracket bolts from strut bracket and then ball stud bolt.
5. Disconnect coupler of ABS wheel speed sensor. (If equipped)
6. Remove knuckle.
INSTALLATION
1. Install knuckle to ball stud on suspension arm and strut bracket. Installing direction of each bolt is as shown. Align knuckle bolt hole with ball stud
groove as shown and install ball stud bolt. Tighten each nuts to specified torque.
2. Connect coupler of ABS wheel speed sensor. (If equipped)
3. Connect tie-rod end to knuckle and tighten tie-rod end castle nut to specified torque. Install new split pin.
4. For installation procedures following the above, refer to steps 1 - 9 at Wheel Hub; Service and Repair.
