SX4 2WD L4-2.0L (2007)
21.
Disconnect the electrical connector at the back side of the motor. The lock release is on the driver side of the connector as plugged into the motor.
22.
Remove the blower motor by removing the two screws.
23.
Pull the tab down then rotate the motor clockwise to release it from the housing.
24.
Use the wet/dry vacuum to remove as much debris as possible from inside the HVAC unit by placing the suction hose into the blower outlet as
indicated.
25.
Install the new filter (95860-80J00) in the location where the filter cover or used filter was removed in step 20.
26.
Re-install the blower motor and glove box.
Disclaimer