SX4 2WD L4-2.0L (2007)
c) Tighten bolts ((1) - (10)) to 40 Nm (4.0 kgf-m, 29.0 ft. lbs.) according to numerical order in figure.
d) In the same manner as in step c), retighten bolts ((1) - (10)) to 58 Nm (5.8 kgf-m, 42.0 ft. lbs.).
e) Tighten bolts ((11) - (22)) to specified torque according to numerical order in figure.
Tightening torque
Crankcase bolt with 10 mm thread diameter ((1) - (10)): Tighten 40 Nm (4.0 kgf-m, 29.0 ft. lbs.), 0 Nm (0 kgf-m, 0 ft. lbs.), 40 Nm (4.0
kgf-m, 29.0 ft. lbs.), 58 Nm (5.8 kgf-m, 42.0 ft. lbs.) by the specified procedure Crankcase bolt with 8 mm thread diameter ((11) - (22)):
Tighten 26 Nm (2.6 kgf-m, 19.0 ft. lbs.) by the specified procedure
NOTE:
^
After tightening crankcase bolts, check to be sure that crankshaft rotates smoothly when turned by hand.
^
Use new crankcase bolt (10 mm thread diameter).