SX4 2WD L4-2.0L (2007)
Resistance Check
Resistance Check
1. Remove ECM from its bracket referring to Engine Control Module (ECM) Removal and Installation.
CAUTION: Never touch terminals of ECM itself or connect voltmeter or ohmmeter (2).
2. Connect special tool to ECM connectors (1) securely.
NOTE: Do not connect the other connector of special tool to ECM.
Special Tool
(A): 09933-06320
3. Check resistance Between each pair of terminals of special tool connectors (2) as listed in the following table.
CAUTION:
^
Be sure to connect ohmmeter probe from wire harness side of coupler.
^
Be sure to turn OFF ignition switch for this check.
^
Resistance in the following table represents that measured when parts temperature is 20 °C (68 °F).
