SX4 2WD L4-2.0L (2007)
21. Repair the leak.
22. Perform the pressurization test again referring to EVAP Leak Check System Leak Inspection and check whether the leak is completely repaired.
23. Charge the battery as necessary.
NOTE: After the tester has been used in SMOKE mode, smoke may condense inside the nitrogen/smoke hose, turning into an oil. Over time, this
buildup of oil could degrade the performance of the tester. Use the following procedure any time the tester has been used in SMOKE mode and
will be set aside for a long period of time.
a. Close the valve on the nitrogen tank.
b. Disconnect the nitrogen/smoke hose from the vehicle.
c. Turn the NITROGEN/SMOKE valve to NITROGEN.
d. Press and release the remote switch to activate the tester, and then purge any residual smoke from the nitrogen/smoke hose.
