SX4 2WD L4-2.0L (2007)
21. Wash your hands with mild soap and water afterward.
NOTE: Remaining steps are to be followed in the unlikely event that air bag (inflator) module did not deploy or seat belt pretensioner did not
activate.
22. Ensure that deployment harness has been disconnected from 12 volts vehicle battery and that its two banana plugs have been shorted together by
fully seating one banana plug into the other.
23. Disconnect deployment harness and adapter cable from air bag (inflator) module or seat belt pretensioner.
24. Temporarily store undeployed air bag (inflator) module referring to Precautions on Service and Diagnosis of Air Bag System:Except advanced Air
Bag for details.
25. Contact your local distributor for further assistance.
Deployment / Activation Inside of Vehicle
When the vehicle will be destroyed, or salvaged for component parts, deploy the air bag modules and/or activate seat belt pretensioners installed on
vehicle.
NOTE: If equipped with the seat belt pretensioners, activate both side of seat belt pretensioners at the same time when using special tool (C).
1. Turn ignition switch to LOCK position, remove key and put on safety glasses.
2. Remove all loose objects from front seats and instrument panel.
3. Disconnect air bag (inflator) module or seat belt pretensioner connector as follows.
^
For driver air bag (inflator) module [A]: Remove driver side front pillar lower trim and disconnect driver air bag (inflator) module connector
(1).
^
For passenger air bag (inflator) module [B]: Remove passenger side front pillar lower trim and disconnect passenger air bag (inflator) module
connector (2).
^
For seat belt pretensioners (right and left) [C]: Remove both side (driver and passenger side) center pillar lower trim and disconnect seat belt
pretensioner connectors (3).
4. Confirm that each air bag (inflator) module and/or seat belt pretensioners is securely mounted.
