SX4 2WD L4-2.0L (2007)
d. Tie seat belt pretensioner (2) with wire harness (3) to wheel-installed tire (4) as shown.
Wire harness specifications
Stripped wire harness section 1.25 sq.mm (0.0019 sq.in) or more (Stripped wire harness diameter 1.25 mm (0.05 in.) or more)
NOTE: Wind wire harness (3) around at least 3 times.
e. Clear space (5) on ground about 185 cm (6 ft) in diameter where seat belt pretensioner (2) is to be activated. Paved, outdoor location
where there is no activity is preferred. If outdoor location is not available, use space on shop floor where there is no activity and sufficient
ventilation is provided. Ensure no loose or flammable object exists within activation area.
f.
Place wheel-installed tire (4) with seat belt pretensioner (2) on ground in Step e.
