SX4 2WD L4-2.0L (2007)
Steering Wheel: Service and Repair
Steering Wheel Removal and Installation
CAUTION: Do not turn the contact coil more than allowable number of turns (about two and a half turns from the center position clockwise
or counterclockwise respectively) with steering wheel removed, or coil will break.
Removal
CAUTION: Do not hammer the end of the shaft. Hammering it will loosen the plastic shear pins which maintain the column length and
impair the collapsible design of the column.
1. Disconnect negative (-) cable at battery.
2. Disable air bag system.
3. Remove driver air bag (inflator) module from steering wheel.
4. Disconnect horn connector and audio control switch connector, if equipped.
5. Remove steering shaft nut and then make alignment marks (1) on steering wheel and shaft for a guide during reinstallation.
6. Remove steering wheel using special tool.
Special Tool (A):09944-36011